The Global Warming quilt top is finished!
It really wasn’t that hard.
Once I had all 4 of the segments done, I stacked them up with the center 4 squares on top of each other- all the segments facing up. I tried to carefully get all the seams matched and pinned all 4 sides so they would stay all together.
Then I got out my tape measure (the pattern called for a yardstick but I didn’t have one) and started marking my curve. The pattern called for it to be at 36 inches but since my quilt came out a little smaller, I marked my curve at 35.5 inches. I wanted to keep my curve at about the same place as the curve in the pattern.
After measuring and marking and re-measuring, it was time to cut. I just used my scissors and cut along the line I had marked.
Here’s the quilt all laid out and ready to have the curves sewn.
Normally when I sew curved pieces, I find the center of each piece and line them up first. With this quilt, it was more important to line up the seam lines of each block. Most of the time they lined up pretty well and the whole thing wasn’t too hard to put together. I used A LOT of pins which always helps when doing curves.
So there it is: “A Global Warming Quilt No 1” by Anthology. I bought some really bright yellow backing and it’s going to the quilters next week. I think I’m just going to sew some of the left over batik strips together to make a colorful binding.
I’ll share the finished quilt with you when it’s all done.
I’ve finished all 100 blocks for the Global Warming quilt – and 5 seasons of Gilmore Girls on Netflix! (Hey, you have to have something to make those boring blocks go faster.) I laid them out and now I’m sewing them into 4 sections.
I have to say this about the blocks- many of mine didn’t come out at 8.5 inches. I puzzled over this because some did and I double checked my seam allowance but then I decided that maybe these jelly roll strips are a little off. Some were 2.5inches but some were not quite there. Then I noticed a small note in the pattern that said, “Strips may vary in width. You can deal with it!” I guess they were referring to what I had discovered. It’s definitely not the end of the world but the blocks really need to be the same size to all fit well together so I ended up cutting all the blocks down to just over 8 inches. I hope this is the right way to deal with it.
One of the sections has the light blocks, one has the dark and the other two are medium value blocks. I noticed that I had a lot of yellow and orange blocks in my medium values so I decided to put those together in one of the sections and the other medium section has more blues and greens. I’m hopeful that when I cut the large circle out and turn it, this layout will create the most contrast.
So the next step is to stack these 4 sections, pin them and mark a 36 inch arc and CUT it. (How scary is this?) Then move the circle pieces and sew everything back together.
It sounds like it could be cool. It also sounds like things could go badly. I will be holding my breath while I perform these feats of magic. (And taking photos so I can let you know how it goes.)